|
Tubes and primers are used to ignite the propellant in projectile weapons. In ancient times various devices were adopted to ignite the charge. Small guns were fired by priming powder poured down the touch hole (or vent) and ignited by glowing embers or a red-hot iron rod. Later the priming powder was ignited by a piece of slow match held in a linstock (a stick with a clamp at one end). About 1700, this was effected by means of a port-fire. This was a paper case about 16 inch (406 mm) long filled with slow-burning composition which burnt rather more than one inch (25 mm) per minute. Later again the charge was exploded by paper tubes (sometimes called Dutch tubes) filled with powder and placed in the vent and ignited by a port-fire. In comparatively modern times friction tubes have been used, while in the latest patterns percussion or electric tubes are employed. ==Vent sealing tubes== In most breech loading guns it is essential to stop the erosion of the metal of the vent by preventing the escape of gas through it when the gun is fired. For this purpose the charges in such guns are ignited by "vent-sealing tubes." For muzzle loaded guns and small breech loading guns radially vented, especially those using black powder, the amount of erosion in the vent is not so serious. The charge is fired by ordinary friction tubes, which are blown away by the escape of gas through the vent. In all guns axially vented, vent-sealing tubes, which are not blown out, must be employed to protect the gunners from injury. The common friction tube is a copper tube, packed with powder, having at the upper end a short branch (called a nib piece) at right angles. This branch is filled with friction composition in which a friction bar is embedded. When the friction bar is sharply pulled out, by means of a lanyard, the composition is ignited and sets fire to the powder in the long tube; the flash is conveyed through the vent and ignites the gun charge. For naval purposes, to prevent the sailors from being cut on the face or hurting their feet, tubes of quill instead of copper were used. If friction tubes are employed when cordite or other smokeless powder charges are used, the erosion of the vent is very rapid unless the escape of the gas is prevented; in this case T-headed tubes are used. They are similar in action to the ordinary type, but are fixed to the vent by the head fitting a bayonet joint formed with the vent. The explosion blows a small ball upwards and blocks the coned hole at the top of the tube and so prevents any rush of gas. The vent-sealing tube accurately fits into a chamber formed at the end of the vent, and is held in place by the gun lock or some similar means. The force of the explosion expands the tube against the walls of its chamber, while the internal structure of the tube renders it gas-tight, preventing any escape of gas through the vent. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Tubes and primers for ammunition」の詳細全文を読む スポンサード リンク
|